Announcement
Collapse
No announcement yet.
What should I fill my bike with?
Collapse
X
-
Forum GuruPast Site Supporter
Super Site Supporter- Jun 2018
- 5536
- Mifflinburg, PA / Land of Tar & Chip
So the short answer is ....... Gas. Fill it with gas. And ride it.Rich
1982 GS 750TZ
2015 Triumph Tiger 1200
BikeCliff's / Charging System Sorted / Posting Pics
Destroy-Rebuild 750T/ Destroy-Rebuild part deux
-
I put in high compression pistons in a Triumph Sprint 900. Never checked to see what gas i should use with the new pistons. Dyno tuning confirmed a lean spot at 5000+/- rpms. That is right were the bike ran 75% of the time. Heaven forbid my cheap ass would spend .07 cents on a gallon gas, nope. 24k later, porcelain part of spark plug broke off and dropped into the cylinder. Took out 3 of 4 valves. Fixed, but did not fix the cause, (lean detination)which I knew, but was to stubborn to address it. 20k later it happened again. Engine basically toast. Same issue. Moral of the story: 1) I'm a stubborn old German. 2) Any mods to motor/carbs/exhaust will change fuel requirements from stock, so paying more for gas is like paying for health insurance. Ya hate paying for it while your healthy but glad you have it when you get sick. 3) Run what ever your comfy with, but I have to much $$ tied up in carbs and dyno work to save $2 a tank. I've simplified it. On my everyday drivers I use 87. Everything else I use 91 non-oxy, Lawn mowers, snow blowers, weed whips, chain saws ect. That same Triumph would barely start after sitting 3 weeks. Had to drain carbs. In my truck which gets run maybe 1x per mo, I have started using Star-Tron(cuz its cheaper! lol)) as I had severe water/fuel issues with truck from letting it sit with 87 octane.Last edited by limeex2; 03-22-2020, 12:38 PM.Current Rides: 82 GS1100E, 00 Triumph 955 Speed Triple:twistedevil:, 03 Kawasaki ZRX1200, 01 Honda GL1800, '15 Kawasaki 1000 Versys
Past Rides: 72 Honda SL-125, Kawasaki KE-175, 77 GS750 with total yosh stage 1 kit, 79 GS1000s, 80 GS1000S, 82 GS750e,82 GS1000S, 84 VF500f, 86 FZR600, 95 Triumph Sprint 900,96 Triumph Sprint, 97 Triumph Sprint, 01 Kawasaki ZRX1200, 07 Triumph Tiger 1050, 01 Yam YFZ250F
Work in progress: 78 GS1000, unknown year GS1100ES
Comment
-
Originally posted by greg78gs750 View PostSteve and bwinger are right on, 87 regular standard ethanol blend here and never any problems in....15ish years of gs ownership.1979 CBX, AW440 Maico, GS1150EF
http://www.thegsresources.com/_forum...ine=1447792849
Comment
-
whatevers fine id say, saw a report that said 89 was the best for the bike for performance but im sure 87 doesnt make it run like ####. if your bike doesnt always get ridden and may sit around for a bit, non ethanol doesnt degrade as fast as ethanol and wont cause corrosion or rust (as easy, not entirely sure)Ian
1982 GS650GLZ
1982 XS650
Comment
-
My Girls:
1978 Honda Goldwing GL1000 " Valerie" - Project
1982 Suzuki GS1100G "Beauty" My Daily Rider
1983 Kawasaki KZ1100 LTD "Amber" - Project
1978-1982 Yamaha XS1100 Special "Sweetness" - I'm still looking for her.
Comment
-
Originally posted by 80GS1000 View PostI run 91 octane booze free petrol in my GS but only because it has high compression 10.25:1 pistons to prevent pinging/detonation.
My wife's new ride has 12.0:1 compression ratio and runs just fine on 87 octane with up to 10% ethanol.
I have tried running 93 octane when available for several hundred miles, keeping a log book, of course, and found absolutely NO difference in performance or gas mileage, so we are sticking with the affordable 87 octane.
Yeah, it's a water-cooled three cylinder engine, but it's still 12.0:1 compression.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.)
Comment
-
Originally posted by Steve View PostCompression ratio alone is not the reason to run higher-octane fuel.
My wife's new ride has 12.0:1 compression ratio and runs just fine on 87 octane with up to 10% ethanol.
I have tried running 93 octane when available for several hundred miles, keeping a log book, of course, and found absolutely NO difference in performance or gas mileage, so we are sticking with the affordable 87 octane.
Yeah, it's a water-cooled three cylinder engine, but it's still 12.0:1 compression.
.
Glad the 87 octane works out for you all on that triple.
In an old-school high compression air-cooled engine like my bored out GS1000 without an ECU or any other of the electronics mentioned above, I feel that running high octane fuel is cheap insurance against ping/knock and associated engine damage especially during the hot summer season. And especially because it has a one-size-fits-all static spark curve (CDI ignition) and static fueling (carbs).
YMMV.Last edited by 80GS1000; 09-21-2020, 04:32 PM.
Comment
-
Forum GuruPast Site Supporter
Super Site Supporter- Jun 2018
- 5536
- Mifflinburg, PA / Land of Tar & Chip
On a bit of a tangent:
Has anyone heard from the OP, ZombiePotatoSalad. His last post was a video of his bike finally running and him riding it on 6/25/20. I sent him a PM out of concern on 8/6, but got no response. He’s a very inexperienced rider, just starting to get his brasketcase of a bike on the road. He’d been a regular poster up until that video. Many of us had been trying to help him along with advice and encouragement. Hate to think about anything that May have happened, but my mind goes to dark places sometimes.Rich
1982 GS 750TZ
2015 Triumph Tiger 1200
BikeCliff's / Charging System Sorted / Posting Pics
Destroy-Rebuild 750T/ Destroy-Rebuild part deux
Comment
-
Originally posted by 80GS1000 View PostYour wife's bike probably has an ECU along with modern electronics like knock sensors, EFI etc which takes temperature/air pressure/RPM/engine load and many other variables into account in terms of dynamically controlling the spark timing and fueling. These modern electronics help prevent pinging and deliver the correct amount of fuel at all times.
I was not trying to say that your bike would run fine on 87, just saying that higher compression was not the only reason to use higher-octane fuel. There are definitely many reasons to use higher octane. If I remember correctly some of the carbureted Harleys had a relatively low (less than 8:1?) compression ratios, but still required high-octane fuel, due to the heat in the engine and the large diameter cylinder bore.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.)
Comment
-
Originally posted by Rich82GS750TZ View PostOn a bit of a tangent:
Has anyone heard from the OP, ZombiePotatoSalad. His last post was a video of his bike finally running and him riding it on 6/25/20. I sent him a PM out of concern on 8/6, but got no response. He’s a very inexperienced rider, just starting to get his brasketcase of a bike on the road. He’d been a regular poster up until that video. Many of us had been trying to help him along with advice and encouragement. Hate to think about anything that May have happened, but my mind goes to dark places sometimes.My Girls:
1978 Honda Goldwing GL1000 " Valerie" - Project
1982 Suzuki GS1100G "Beauty" My Daily Rider
1983 Kawasaki KZ1100 LTD "Amber" - Project
1978-1982 Yamaha XS1100 Special "Sweetness" - I'm still looking for her.
Comment
-
Originally posted by 80GS1000 View PostYour wife's bike probably has an ECU along with modern electronics like knock sensors, EFI etc which takes temperature/air pressure/RPM/engine load and many other variables into account in terms of dynamically controlling the spark timing and fueling.1982 GS1100GL: hand built stainless 4-1 exhaust, pods, jetting.
Comment
-
My 82 GS1100 liked it's octane at 91 or better in hot weather. Ethanol is less likely to ping & I could run the grade lower 89 with the same results. My 81 GS850 seems to not care what's in it. My bikes are currently 1977, 1981, & 1984, and a 2010 maxi scooter. I have never had one iota of trouble with ethanol in any of them, and here in Iowa it's cheaper by a bunch. The only fuel injected one in the bunch is the scooter.
Comment
Comment