650 gs carbs...Steve?

[keso151]

Thanks to all who helped me on these carbs… I have been out of commission with the bike for a while so just today had the carbs installed and as you predicted the fuel tee is pretty loose and it did leak so I’m letting it sit in the fuel for a while to see if that will help…if not we’ll pull it apart and possibly buy a new T or O-ring it …is there a kit for that one?
By the where the bike fired right up and ran pretty good till the leaking started… thanks four help…. and to Storm64 the Original carburetors never did come back from Steve he kept them.

[keso151]

Fuel T has stopped leaking and reset idle ,,,,purrs like new! Will get it out this weekend to test!

[steve murdoch]

Glad to hear you finally get to ride it.

[keso151]

Well we are taking it slow the guy at work is really good with bikes and we’re finding out the number two cylinder from the left is not firing we have spark so I’m thinking the number two carburetor must be a little stuck

[chuck hahn]

Try a NEW plug first. I have had them spark like mad... put it in and it womt kick. Might save you a lot of unneeded crap.

[Nessism]

That carb wasn't plugged when it left my shop. Do you have rust in the gas tank? Have you checked the valve clearances?

[2BRacing]

.............we are finding out the number two cylinder from the left is not firing we have spark so I am thinking the number two carburetor must be a little stuck

Also check if a faulty fuel tank petcock is not dumping excess fuel down the vacuum hose into number 2 cylinder, killing the fire.

[keso151]

thanks for the help here… it looks like it’s getting spark and we switched the wires and it didn’t make a difference when you pull off the number two wire.. the bike didn’t idle down so spark is good.. changed the plugs and it worked fine on number one so plugs are good drain the number two bowl and it has fluid in it so don’t want to Drive it and possibly burn down number two.. I will check that petcock with the vacuum hose…

[keso151]

ok..heres an update......installed carbs and had a Forum cylinder issue...nonfire... well a rookie mistake no vent tube installed!! will install tomorrow as the bike is still at my workplace..fingers crossed.
2 more questions...the intake boot clamps seem to bet "tight" but they are mostly all the way together.and 1 is a hose clamp..(i'll try and find one..) so is this ok? or are the boots losing their thickness...2nd question ..should all fuel/vent hoses have the rubber spring clamps...seem to be missing a few..