Announcement

Collapse
No announcement yet.

starter and heat

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    starter and heat

    The starter is very sluggish to not working when hot. First thought is bad starter so I removed it. Can't see a thing wrong. brushes are fine com is fine
    Bearing play is just decernable. Turns freely, no sign of rubbing. Cable connection clean and tight. Relay connections the same. When cold works like a charm. I guess I s hould mention that this is an 84 gs250T
    alex
    Last edited by Guest; 08-25-2010, 10:27 PM.

    #2
    Might help to also mention how good the battery is.

    Check the voltage before you turn the key ON.

    Check the voltage after turning the key ON, but before starting the bike.

    Check the voltage with the engine idling.

    Check the voltage with the engine at 2,000 RPM.

    Check the voltage with the engine at 5,000 RPM.

    Report back with the results.

    .
    sigpic
    mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
    hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
    #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
    #2 son: 1980 GS1000G
    Family Portrait
    Siblings and Spouses
    Mom's first ride
    Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
    (Click on my username in the upper-left corner for e-mail info.)

    Comment


      #3

      Comment


        #4
        starter and heat

        battery is fine. Actually it is new at least it was new last fall. The voltage is up to scratch 12.5 no load of course it takes a beating when the starter fails to turn. when cold no problem. I am going to try a different battery although I feel this one is ok. However I can find no other likely source of the problem.
        alex

        Comment


          #5
          So, what is the voltage at the battery when you push the starter button?

          And all those other readings Steve asked for?
          1978 GS 1000 (since new)
          1979 GS 1000 (The Fridge, superbike replica project)
          1978 GS 1000 (parts)
          1981 GS 850 (anyone want a project?)
          1981 GPZ 550 (backroad screamer)
          1970 450 Mk IIID (THUMP!)
          2007 DRz 400S
          1999 ATK 490ES
          1994 DR 350SES

          Comment


            #6
            At 12.5 volts, it's not quite "up to scratch".

            .
            sigpic
            mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
            hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
            #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
            #2 son: 1980 GS1000G
            Family Portrait
            Siblings and Spouses
            Mom's first ride
            Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
            (Click on my username in the upper-left corner for e-mail info.)

            Comment


              #7
              Originally posted by Steve View Post
              At 12.5 volts, it's not quite "up to scratch".

              .
              I believe that 12.5 12.6 are quite normal for a 6 cell lead acid battery at rest.
              alex

              Comment


                #8
                some representative curves.




                At least for my battery at 65 degF if it will be at about 12.5 volts after sitting for about a week. If it was just charging it would be closer to 12.8-12.9v which is probably indicative of a bit of surface charge that comes off pretty quick.

                After pulling off the charger , I can turn the headlights on for a few seconds and it still seems to come back to read over 12.8v

                Comment


                  #9
                  Originally posted by posplayr View Post
                  some representative curves.




                  At least for my battery at 65 degF if it will be at about 12.5 volts after sitting for about a week. If it was just charging it would be closer to 12.8-12.9v which is probably indicative of a bit of surface charge that comes off pretty quick.

                  After pulling off the charger , I can turn the headlights on for a few seconds and it still seems to come back to read over 12.8v
                  Sounds about right for a battery in good condition. I think the theoretical voltage is appox 2.2 volts per cell hence the 13.2 volts for a fully charged battery. However in the real world this is hard to obtain. My charging system seems to level off at 15volts at 4k and above. Higher than I would like.
                  alex

                  Comment


                    #10
                    Originally posted by atrent View Post
                    Sounds about right for a battery in good condition. I think the theoretical voltage is appox 2.2 volts per cell hence the 13.2 volts for a fully charged battery. However in the real world this is hard to obtain. My charging system seems to level off at 15volts at 4k and above. Higher than I would like.
                    alex
                    Rule of thumb C/10 would have the R/R output set at 14.5V/100 SOC which is pretty typical. The Suzuki R/R's are pretty loosey goosey with an upper allowable range of 15.5 IIRC.

                    Anyway, this is really relatively independent of the at rest battery voltage which is not really even given in the curves as they assume at least C/100 Charge / Discharge and there is a significant discontinuity there.

                    Actually getting a closer look at the last chart is showing 12.7V at C/100 discharge and 13.35 ish at C/40 charging. So the lower chart confirms voltages in high 12's even possibly over 13V for topped off batteries.

                    So immediately after a ride if you are are at 12.5V I would say you are probably not charging very well.
                    Last edited by posplayr; 08-27-2010, 04:01 PM.

                    Comment


                      #11
                      Originally posted by posplayr View Post
                      Rule of thumb C/10 would have the R/R output set at 14.5V/100 SOC which is pretty typical. The Suzuki R/R's are pretty loosey goosey with an upper allowable range of 15.5 IIRC.

                      Anyway, this is really relatively independent of the at rest battery voltage which is not really even given in the curves as they assume at least C/100 Charge / Discharge and there is a significant discontinuity there.

                      Actually getting a closer look at the last chart is showing 12.7V at C/100 discharge and 13.35 ish at C/40 charging. So the lower chart confirms voltages in high 12's even possibly over 13V for topped off batteries.

                      So immediately after a ride if you are are at 12.5V I would say you are probably not charging very well.
                      Actually right at shut down the voltage is just above 13 but it drops to about 12.6 in a fairly short time. Less than 30 minutes. It does seem to hold the 12.6. This is a Walmart battery made in china and is about 1 year old.

                      Comment


                        #12
                        Originally posted by atrent View Post
                        Actually right at shut down the voltage is just above 13 but it drops to about 12.6 in a fairly short time. Less than 30 minutes. It does seem to hold the 12.6. This is a Walmart battery made in china and is about 1 year old.
                        so it sounds like you are in really good shape ; hope you enjoy the ride.
                        Last edited by posplayr; 08-28-2010, 12:38 PM.

                        Comment

                        Working...
                        X