Finally going to figure out these wires....

[Johnny K]

I've had these wires not connected at all on my bike for the longest time and now that I just bought a new battery, I am going to figure it out. Here is my problem: The signal generator (3 separate plugs) http://www.bikebandit.com/1982-suzuk...6124#sch264957
From the front part of the bike to the rear, the 1st plug set there are 2 wires (orange/white + black/white) That were supposed to go up towards the coils, but is mickey moused and is not connected at all. The orange/white wire next to the coils is soldered to (2 wires with a male connector). From my dyna S ignition red wire I have soldered 3 wires from the red wire coming from the ignition. 2 yellow wires going to either top terminal of the coil and then a wire with a crimped on female part plugged into the orange/white wires. I have the 3rd plug set wires (all solid colors) is not connected at all. The male plug is connected to the signal generator fine; but the wires coming out of the female part are not spliced/connected to any other wires. It's difficult for me to follow the diagram to find out where they should be connected to. When tracing the wires and looking on the diagram, there are a couple more splices that I can't figure out why they are there in the first place and so forth. Could anyone help me out as to where these wires are supposed to be connected to?

[tom203]

Probably best to continue with old post, so not to confuse us mentally challenged folks! Anyway, you did read my reply to this exact same thing??? Find the wires to the negative side of coils and trace them back to ignitor. Look at the original suzuki ignition wiring diagram for guidance- the dyna has to be similar- if it ain't others will chime in to correct me. Just make sure everyone understands that your harness has been messed with, so wire colors might be different.