Dyna 2000 Install - 78 GS1000E

[gaillarry]

Installing Dyna 2.2 coils that came with the kit.The Dyna 2000 module has 4 wires to the coils, but I need one 12v wire thats switched from the ignition. From the wiring harness I have 2 o/w, a b/w and a y/b. Which one would I use??

[gaillarry]

Forgot about the coil relay mod, I'll do it and use power from the solenoid !!

[SqDancerLynn1]

AS far as two wires, they both end up at the same 12v place!!!

[gaillarry]

Got the coil relay mod done, now have 12v switched power to the ignition coils.

Last step before firing it up is the ignition coils, and this where I'm stuck. The Dyna wiring diagram shows the red wire from the module goes to coil 1/4, then coil 2/3 then to the switched 12v power supply (black wire in pic from the coil mod relay).



I think I'm missing a joint or connector??

[Flatline_Racing]

Red wire connects to both coils and switched positive. So, all 4 wires that you have unconnected in the picture get joined together.

[gaillarry]

Whats a good way to join them together, I dislike twisting them together.