Announcement
Collapse
No announcement yet.
New Battery and it only turn over breifly before solenoid clicks
Collapse
X
-
Ralpha306
New Battery and it only turn over breifly before solenoid clicks
I pulled my gs from storge and put it in my new garage.. Installed new Battery only to find battery only worked a few seconds be for solenoind clicks... let sit for a few seconds more and it turned over a few more time then died..helpTags: None
-
Dumb question but did you charge the new battery?I didnt do it I swear !!
--------------------------
http://i1210.photobucket.com/albums/...Picture003.jpg 1982 GS850G
http://i1210.photobucket.com/albums/...n1/Picture.jpg 1980 GS1100L
-
New batteries need to be charged at a low amp setting for a few hours prior to use, I put mine on a trickle charger at 1 amp for 24 hrs prior to use1984 GS1100GK newest addition to the heard
80 GS 1000gt- most favorite ride love this bike
1978 GS1000E- Known as "RoadKill" , Finished :D
83 gs750ed- first new purchase
85 EX500- vintage track weapon
1958Ducati 98 Tourismo
“Remember When in doubt use full throttle, It may not improve the situation ,but it will end the suspense ,
If it isn't going to make it faster or safer it isn't worth doing
Comment
-
Ralpha306
-
Hoosier Daddy
Can you check the specific gravity to verify it is fully charged? You can pic up a cheap tester at any auto parts store. It looks like a small turkey baster but has balls inside that float at different amounts of charge. Count the number of floaters and read the state of charge.Last edited by Guest; 03-22-2011, 07:27 PM.
Comment
-
Ralpha306
Thats sounds wild.. i put a mmeter and it reads 12.5 but quickly drops when the engine turns over.. drops until engine doesnt turn over any more
Comment
-
Hornswaggle
-
Ralpha306
Comment
-
Charge it longer you just surface charged it min 10 hrs1984 GS1100GK newest addition to the heard
80 GS 1000gt- most favorite ride love this bike
1978 GS1000E- Known as "RoadKill" , Finished :D
83 gs750ed- first new purchase
85 EX500- vintage track weapon
1958Ducati 98 Tourismo
“Remember When in doubt use full throttle, It may not improve the situation ,but it will end the suspense ,
If it isn't going to make it faster or safer it isn't worth doing
Comment
-
Ralpha306
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35619
- Torrance, CA
2.5 amps is too fast. For a 14 a-h battery you should charge at 1.4 amps max.
So assuming the battery is okay, you might want to clean your battery cables - both where they attach to the battery and where they attach at the starter solenoid and ground.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
BassCliff
Hi,
If new batteries are not properly initialized you can ruin them. Let's hope that didn't happen. Here's an article: Battery Charging
Thank you for your indulgence,
BassCliff
Comment
-
Ralpha306
i went out and bought a new charger.. it charges at 1amp and i charged for 8hr last night.. connected it after work today and nothing same response..
1. Did i mess up the battery?
2. could it be the starter is having a hard time turning the engine?
Comment
-
Ralpha306
Just Frustated....Thanks...
I Guess i just buy a high dollar battery from somewhere other than walmat and see if that helps the problem.....
Comment
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35619
- Torrance, CA
Originally posted by Ralpha306 View PostI Guess i just buy a high dollar battery from somewhere other than walmat and see if that helps the problem.....Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
Comment