Dying while driving.

[trinitysj]

So I am cruising down the highway last night and the bike goes completely dead. I mean NOTHING!. was a little scarry at first.. dropped a gear and tried to rollstart it to no avail.. limped it over to the side of the road safely and started looking....

This is what I found:

* all the fuses were good... replaced all of them earlier.
* when i slid the fuses side to side I got contact again and the bike was fine.
* not sure if the clips for the fuses are bad or expanding when getting hot and losing connection. or maybe corroded.. although they did not look it when inspected.

any ideas?

R

[DanTheMan]

Do what I did. Buy an aftermarket blade type fuse block, and replace the ancient glass fuse block. Then those dieing while driving problems disappear. I thought maybe you were going to tell us somebody died while driveing and you had to avoid them....

[trinitysj]

Alas no....

that is another story that did happen to me long ago.

so replace it with the aftermarket blade type one. I saw that on your website. did not look too hard to do. will give that a shot.

although, will i have the same problem down the road later with the new one too?

R

side note: where do you guys get that map of where you have been?