not firing on 2 and 3- options?

[jstone8952]

[QUOTE=mike_of_bbg;1424119]1) you must also swap the coil primary connectors for this to work (basically you'd make your 1&4 coil your 2&3 coil and vice-versa). If 2&3 start firing then you probably have a bad coil or wirign.

this is as simple as pulling the plug in connectors and switching them?

[Sandy]

[QUOTE=jstone8952;1424120]

1) you must also swap the coil primary connectors for this to work (basically you'd make your 1&4 coil your 2&3 coil and vice-versa). If 2&3 start firing then you probably have a bad coil or wirign.

this is as simple as pulling the plug in connectors and switching them?

You got it.

[jstone8952]

ok so i just did this-

i pulled a plug and tested each plug wire with plug in it with the threaded side grounded. only one and four spark. i swapped the wires leading to each coil and i get no spark at all on any wire.

thoughts?

[jstone8952]

does this mean both the ignitor and right side coil are bad?

[mike_of_bbg]

Sounds somewhat likely. Did you check the secondary and primary impedances of the coils? Sometimes the boots can go bad completely open.

[jstone8952]

ill try swapping the boots.