82 gs1100gk ignitor wiring

[theliverkid]

Okay, I have two 4 prong plugs on my ignitor one black one red. I know where the black plug lands. my question is with the red plug. I have 4 wires, a white, a orange w/wht, a black w/white,and a black w/yel. Black w/yel goes to the negative of one coil, white goes to the negative of the other coil. The orange with white splits into 3 wires, two of them leading to the positive of the coils and than the other leg going ???? And then there is the black w/wht where does it go??? For those reading this I am building a new extremly simplified wiring harness, and dont understand what the two wires function or destinations are.

[Matchless]

Okay, I have two 4 prong plugs on my ignitor one black one red. I know where the black plug lands. my question is with the red plug. I have 4 wires, a white, a orange w/wht, a black w/white,and a black w/yel. Black w/yel goes to the negative of one coil, white goes to the negative of the other coil. The orange with white splits into 3 wires, two of them leading to the positive of the coils and than the other leg going ???? And then there is the black w/wht where does it go??? For those reading this I am building a new extremly simplified wiring harness, and dont understand what the two wires function or destinations are.

The White and the Black/Yellow go to the two coils.
The Orange/White wire is the switched power from a fuse that feeds both the coils and the ignitor, via the kill switch (and also used by the start button) when ignition is on.
The Black/White is the ground for the ignitor. It is a tail from the common Black/White running the length of the harness from the battery.

Hope this helps you.

[theliverkid]

okay So I just need to feed 12v to the coil and ignitor on that wire from a switch, and by killing that power kills thr bike?

[Matchless]

You have it and the starter button is after the kill switch using the same power line.

[Nessism]

Free factory service manual download here... http://www.mtsac.edu/~cliff/storage/...ice_Manual.pdf

[posplayr]

Okay, I have two 4 prong plugs on my ignitor one black one red. I know where the black plug lands. my question is with the red plug. I have 4 wires, a white, a orange w/wht, a black w/white,and a black w/yel. Black w/yel goes to the negative of one coil, white goes to the negative of the other coil. The orange with white splits into 3 wires, two of them leading to the positive of the coils and than the other leg going ???? And then there is the black w/wht where does it go??? For those reading this I am building a new extremly simplified wiring harness, and dont understand what the two wires function or destinations are.

this is about as simplified as you want it.

http://www.thegsresources.com/_forum/showthread.php?t=153727&highlight=550+bobber