Bike is a 1977 gs550
I have done the coil relay mod and have good voltage to the coils. I'm not getting spark on spark plug 2 and 3. Did the primary and secondary ohm test on the good and bad coil,both were the same ( can't remember, but I think it was something like 4.8 primary and 26k secondary). Swapped over the black and white wires to eliminate it being a dyna-s ignition fault.
Tested the plug caps... 3 of them had 4.8ohms and one was a dud. Replaced that but still no spark at that coil, trimmed down all leads to eliminate corroded leads etc. Tested the earths and all connections.... every thing fine.
So next, I tried a coil off my bandit motor and hey presto! I have spark at 2 and 3!
So anyway, here's my question: coils tested fine, plug caps good, voltage to coils all correct.. But no spark. Can a coil test as fine,as this one has but still fail to produce spark? I'm no electrical guru so im gonna replace the coils anyway but was wondering if there's some test I have missed that would have shown me what is/ isnt going on with this coil as when tested as above it seemed fine?
Cheers.
Here's some shots of the bike in case anyone's interested:
Comment