Connector for Stator Electrical Cable - Where is It?

[Guest]

I pulled the generator cover off of my '83 GS650GL to polish it up using my buffing motor.

The new gasket has a separate area around a small section near the top right where the stator electrical cable disappears into the side of the engine. There is no way to get the cable through that gasket without disconnecting the electrical cable and threading it through that separate section of the gasket.

There is no disconnect on the cable inside the generator cover itself. So, where the heck is the connector to get the cable free? It looks like it might head into the starter motor well. It the connector in there, or somewhere else?

Someone tell me please, so I don't have to take a ton of stuff apart to find it!

Thanks!

[terrylee]

It does go into the starter area, so remove cover and follow wires back to r/r and if stator is not wired directly to r/r, there will be two wires that go towards front of bike near fusebox . Then just pull wires through opening inside side cover and through gasket and should be good to go. terrylee

[adam]

https://www.youtube.com/watch?v=l7-2PSejfyQ hopefully this link will help