Announcement

Collapse
No announcement yet.

7 wire Rectifier / Regulator NEED HELP with hook up locations

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    7 wire Rectifier / Regulator NEED HELP with hook up locations

    I have a 7 wire r/r ready to install into the 1979 GS1000 project. I picked this up on ebay a few years ago but forgot the original application. Think it was a Honda GW - not sure??

    Can anyone ID this r/r. Also some help with this 7 wire installation - three black wires - two black with red stripe - two black with white stripe. Any help much appriciated. Thanks
    Attached Files

    #2
    hazard a guess, go find the manual for the Honda,

    Comment


      #3
      IF one were a gambler, one might speculate that it COULD be very similar to a 7-amp 2008 Rectifier/Regulator knock-off from China, very similar to the link below.

      The color codes on the wires do not match your image on the epoxied heat sink, perhaps the connectors are wired correctly, scroll down the page for images...

      http://www.aliexpress.com/store/prod...003871594.html

      Everyone I ever talked to all say that they made a KILLING in Las Vegas, amazing that place is still in business...

      Save your pennies, buy a Compu-Fire and have Jim wind a Stator for you...

      Here is your Technical Service Manual from Suzuki (BikeCliff's)
      Last edited by Guest; 11-12-2014, 04:15 PM.

      Comment


        #4
        Probably a shunt type RR to boot.
        sigpicMrBill Been a GSR member on and off since April 2002
        1980 GS 750E Bought new in Feb of 1980
        2015 CAN AM RTS


        Stuff I've done to my bike:dancing: 1100E front end with new Sonic springs, 1100E swing arm conversion with new Progressive shocks installed, 530 sprockets/chain conversion, new SS brake lines, new brake pads. New SS fasteners through out. Rebuilt carbs, new EBC clutch springs and horn installed. New paint. Motor runs strong.

        Comment

        Working...
        X