for years ever since i bought the bike 6 years ago.
Issue:
-Smoke and heat seen in the piranha elec ignition box. Was very hot
-Only runs on 2 cyl - 2/3 cyl (of course 1/4 cyl runs off a separate coil)
-I noticed the horn - was not connected and rattling about still connected over the engine !
(wander if this could have shorted something ?)
So on this run after 30 miles of perfect running i stopped for petrol as i thought it had just gone on reserve.
It had not and gone onto 2 cylinders! Bike ran fine but only on two cylinders.
Stopped and checked and was only running on Cyl 2/3 thus i thought the coil for 1/4 must be faulty.
No fuses gone / bike all ok bar that.
Hobbled back home on two cylinders and no heat smoke ...
today
-The coil for Cyl 1/4 had melted plastic around one of the connecting posts.
(madly the primary still tests ok still (3.5ohms)
-No fuses gone
-All other electrics fine
-I have checked all connections, any bad looking ones I made new double crimp
connectors so the wiring is now perfect.
-the plugs, ht leads and plug caps are ok.
Put on a spare coils and exactly the same issue - only runs on 2 /3 cyl.
Q) Do you think i have fired the electric ignition ?
(It looks ok)
Q) do you think the horn rattling about near the ht leads could have caused something ?
Remember on the way back with this horn on correctly i had no issue at all - bar being on 2 cylinders)
Q) Is there anything lese i can test before buying a expensive elec ignition ? (£140)
Q) If i have fried the elec ignition and if so where can i get a piranha type ?
or do i change and use a dynatec , dyna s one.
Background:
I had an issue a few weeks back wth the type of regulator used on this bike. (one with a sense wire, cant be standard)
This I am sure I have sorted with the sense wire attached to the rear brake live switched wire.
Due to this not connected for a time .... it fried a coil a few weeks back ! the same side , 1/4 Cyl, i am having an issue with now.
This however blew fuses !!!!
Be aware this time there are no blown fuses.
I almost think this previous issue damaged the elec ignition ?
Your thoughts would be so appreciated !
current piranha ignition.jpg
Comment