Tip for getting wires in sleeve?

[Guest]

Installing a new electro sport stator. Any tips on getting the 3 yellow wires through the plastic sleeve? Can get 2 easily, but not 3.

thanks.

[Nessism]

You might try shooting some WD-40 inside the tube

[Steve]

If you have terminals on the ends of the wires, don't push all three through at the same time.

.

[RobP]

Hi
Tried WD-40.
No terminals on end of wires - just bare wires.

Thanks though.

Rob

[dorkburger]

Find a piece of solid wire. Household 14 gauge is good- or a piece of wire hanger-Tightly tape the 3 wires near the end of the solid wire. Push the solid wire thru, then the pull stator wires thru. When you tape the 3 wires to the solid wire set each one back a bit so the pack of wires is like a wedge shape.

[azr]

Find a piece of solid wire. Household 14 gauge is good- or a piece of wire hanger-Tightly tape the 3 wires near the end of the solid wire. Push the solid wire thru, then the pull stator wires thru. When you tape the 3 wires to the solid wire set each one back a bit so the pack of wires is like a wedge shape.

Solid tip on technique!