Announcement

Collapse
No announcement yet.

Three Dee Thread

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    on this pic, the 'innards' can be seen

    GS.pomolo.odometro.x-ray.png
    GS1000G '81

    Comment


      #32
      ​...also, the 'negative' of the splines, on top, need be so small, that in some sizes they just didn't print (we're looking at 0,45mm - 1.771654in -).​But in the end, I managed to get it about right.
      That's a PLA prototype as it came out of the printer

      trip.reset.knob.jpg









      Last edited by Lorenzo; 06-27-2024, 04:14 AM.
      GS1000G '81

      Comment


        #33
        Time for another add up:
        sick'n'tired of this
        IMG_20241005_190856.jpg



        GS1000G '81

        Comment


          #34
          So I made this:

          IMG_20241014_210050.jpg
          GS1000G '81

          Comment


            #35
            Woops bit over the top with paint

            IMG_20241014_233608.jpg
            GS1000G '81

            Comment


              #36
              Scrub it off, looks better

              IMG_20241014_235530.jpg
              GS1000G '81

              Comment


                #37
                Detail of the embossed lettering:

                IMG_20241017_105009.jpg
                GS1000G '81

                Comment


                  #38
                  The part, were it belongs to:

                  IMG_20241015_000236.jpg
                  GS1000G '81

                  Comment


                    #39
                    Next one I could make the letters RWU ...
                    GS1000G '81

                    Comment

                    Working...
                    X