Cables and such...

[Hammered]

Im getting ready, I hope, to start a bolt-on build. No garage space since I moved back to VA. Ive ditched the old Buckhorns that were oh so cool, , for Daytonas. The cables are a bit long but for the time being were fine. I may be going to drag or clip-on bars for the Cafe/Street fighter thingie whatever look Im shooting for. Im gonna want/need newer and shorter cables for the job. I have no idea of the length and was hoping someone made a "Build your own damn cable!" kit with fittings cables and such. See how nice that tied back into the title of my thread?!?

Thanks

[BassCliff]

Hi,

Cables from the 750E model would probably fit better than the L cables. I don't know of any "build you own" clutch and throttle cable kits.



Thank you for your indulgence,

BassCliff

[koolaid_kid]

When I was at the Gap in 2005, my clutch cable broke. I limped to Walkers and this is what he did:
Cut the outside housing
Placed a new metal piece in the end, just like stock
Cut the inside line to the correct length
Brazed a new ferule onto the cable
Installed the cable and made sure it worked
Took my money and said "If I were you, I'd get that replaced as soon as you got back home".

I'd just find one approximately the correct length and go with it.

[Nessism]

The 550M (Katana) throttle cable is a nice fit with Daytona bars and CV carbs. I don't know how the 750 clutch actuates but you might want to check out some other model bikes with low bars that have a similar clutch. 650 Katana, 1000S, are some other models with low bars and shorter cables.

[Hammered]

Well that sucks. I can shorten the cables easy enough. I can find the ferrules and end stops was just hoping to use a better than OEM cable on this one. No worries. Thanks for the input guys.

[81GS750]

Thread revival!!! Flander's Cables has everything you may need to build your own cables.