Small Project for someone with Access to a lathe (Copper)

[salty_monk]

I have drawings for a conversion washer I've come up with to convert 10mm Banjo brake lines to fit the 8mm engine block fitting on the 83 750.

I am not 100% sure what other models have these 2 oil lines joining block to head but I think there are some others.

It's basically drilling a centre hole & turning a shoulder on some 1/2" copper bar. Easy if you have a lathe... I could do the work myself but I don't!

Anyone here want to have a go at it? I can likely get hold of some copper if necessary.

Too small volume for my lot plus I'm way out of favours at the moment....

[rapidray]

Dan, send Greg B a PM. Ray.

[BassCliff]

Hey Dan, doesn't Ed do that kind of stuff too?


All the best to you and yours,

Cliff

[silverramsrt]

How many pieces do you need? I could find the time to do a few, but not a whole bunch.

Unless of course my location is a problem.

[salty_monk]

Personally I need 4 of them.... But I think there are others who prob have the same issues with the leaking pipes.
It's just a fancy crush washer basically hence the copper. I can supply a CAD file dwg or dxf.

[silverramsrt]

PM sent...

[SVSooke]

Think you will find a bit of demand for these from the 83+ 750/700 crowd.I'm kind of interested myself so I will watching to see how it turns out.

[silverramsrt]

I have the required material. All I need is a blueprint.