.png "Powered by vBulletin")
ok well its bad but...like rusty jeep showed its damn common.
where are you at?
fill in your info.
where are you at?
fill in your info.
-
-
I am in quincy washingtonComment
-
Drive cog tab repair
"drive cog the tabs that interface with the main gear were worn down to half thickness and would not engage at all"
THE SAME THING HAPPEND TO MY DRIVE COG, SO I HAD THE TAB BRAZED USING A GAS TORCH AND FLUX AND BRAZING WIRE.... THE BRAZING LEFT A NICE PILE OF METAL TO GRIND AND FILE BACK DOWN TO REFORM THE DAMAGED TABS....
I DID NOT HAVE PICS, BUT THE BRAZING METAL SEEMED TO ME A HARDER METAL THAN THE STEEL COG ITSELF.....
I HAVE NOT HAD A CHANCE TO INSTALL BACK ONTO THE BIKE, BECAUSE THIS ALL OCCURED TODAY.
THE TABS ENGAGED WELL AND THE UNIT TURNED AS SHOULD AFTER THOUROUGH CLEANING AND GREASE PACKING.
CERTAINLY A CHEAPER FIX THAN A USED CABLE DRIVE ASSEMBLY AND WAY EASIER THAN TRYING TO FIND A REPLACEMENT COG..... ALL SITES I HAVE VISITED DO NOT SELL REPLACEMENT PIECES TO SERVICE THE CABLE DRIVE ASSEMBLYComment
Comment