Announcement
Collapse
No announcement yet.
Changed oil... Runs like crap
Collapse
X
-
NatiKiD
Changed oil... Runs like crap
I have a 80 gs750L. The bike had been sitting for several years. The carbs have been cleaned, rebuilt, and dynojetted last month. The carbs have all been sync'd. I rode the bike for about a week with the oil that was in it when I bought it. Ran great. Starter running a little hesitant shortly after. Found cyclinder 2 running lean. Adjusted the carb to fix that. Anyways I changed the oil with general advance auto parts oil and replaced the filter... Shortly after started going down hill... Started stalling when coming to a stop... Seemed to lack power. Didn't seem like it was before. So! Last night I changed the oil again with rotella oil in the white jug and a new oil filter. Seem to run ok at first.. Then started dying again when coming to a stop. Well if you start it and let it run at idle you can see smoke coming out of the hose that would of went to my airbox (I'm running pods) and the smoke smells like fresh oil. i don't know... Scratching my headTags: None
-
Check your oil for gas
Check your battery1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35852
- Torrance, CA
The problem has nothing to do with the oil.
Please check the Newbie Mistakes thread linked in my signature. It will help steer you in the proper direction to getting your bike up and running.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
Check your oil level with the bike on centerstand, shouldn't go above full mark on sight glass. Too much oil and it'll start pumping it out the breather and anywhere else it can find a cavity.sigpic
Steve
"The world is a book, and those who do not travel read only one page." :cool:
_________________
'79 GS1000EN
'82 GS1100EZ
Comment
-
Originally posted by sedelen View PostCheck your oil level with the bike on centerstand, shouldn't go above full mark on sight glass. Too much oil and it'll start pumping it out the breather and anywhere else it can find a cavity.1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!
Comment
-
Maddevill
Assuming that you didn't overfill it,( And you didn't check the oil level while the bike was on the sidestand, right?) then blowby from that breather indicates you have some bad rings.
Comment
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35852
- Torrance, CA
Originally posted by NatiKiD View PostWhats the smoke coming out of the hose then???
Please tell us you didn't check oil level with the bike on the side stand.The typical GS takes just a little less than one gallon of oil when you change both oil and filter at the same time. If you shoved more than a gallon in the engine, that may be the problem.
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
Comment