.png "Powered by vBulletin")
Quick question about gaskets! I have new gaskets for my carbs, cylinder head cover, breather cover, contact cover? (section i spin while checking valve clearance), and lastly not a gasket but the cylinder head plugs.. the PO seemed to have glued a few of these items in (i had to pull some chunks of stuck glue out of the inside of the cylinder head cover). my question is: what is the best way to install gaskets? is there a product to make it easier in the future to not destroy the gaskets every time? i don't think i salvaged a single gasket on this thing so far.
-
-
Grease the gaskets before install.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
Spray can of white lithium grease is easy to use, some use WD-40, anything really. I tried Anti-Sieze on a few, it didn't work so well.Comment
-
Thanks! I'll try the spray can of lithium. At least if the do stick in the future gaskets are one of the cheaper parts hahaha.Comment
-
So i went to a local store and picked up some Multi-purpose grease. it says #2 grade lithium complex grease on the back. will that be sufficient?Originally posted by Nessism View PostComment
Comment