Announcement
Collapse
No announcement yet.
1978 GS1000 Swing Arm Rebuild
Collapse
X
-
1978 GS1000 Swing Arm Rebuild
I realized my center spacer is gone for my swing arm. I have already pressed in the new bearings. Will a new center spacer fit through the bearings or do I need to remove one of the bearings? Not sure of the center spacer's dimensions. ThanksTags: None
-
Don't hold me to it but I believe the spacer will slide through the bearings and if any seals will go on each side after the spacer is installed. The needle bearings ride on the spacer not between them.sigpic 82 gs1100ez 1168 Wiseco,Web .348 Cams,Falicon Sprockets,Star Racing Ported Head,1mm o/s Stainless Valves,APE Springs,Bronze Guides,etc.APE Billet Tensioner,36CV Carbs,Stage 3 Dynojet,Plenum w/K&N filter,Trued,Welded,Balanced,Crank w/Katana rods & Billet left end, FBG backcut trans, VHR HD Clutch basket,APE nut,VHR High volume oil pump gears,1150 Oil cooler,V&H Megaphone header w/Competition baffle,Dyna S,Coils,Wires,etc.Other misc.mods.
Comment