Announcement

Collapse
No announcement yet.

Oil changes and winter storage

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Oil changes and winter storage

    It's that time of the year again, the bike is about to go hibernation mode for about four to five months. While I change the engine oil before I store it away, it has been brought to my attention that it should also be changed in the spring before starting a new riding season. Curious how many of you follow this, as it got me thinking I may have been inflicting some damage on the engine. Cheers
    1980 GS1100E

    #2
    I leave the old oil in and change in spring myself. I do try and ride every month, looks like you may not get that chance being your from Toronto

    Comment


      #3
      Fearing a bike might set a little too long I did Sta-Bil all of my running bikes today, just in case

      Comment


        #4
        Originally posted by radek22 View Post
        It's that time of the year again, the bike is about to go hibernation mode for about four to five months. While I change the engine oil before I store it away, it has been brought to my attention that it should also be changed in the spring before starting a new riding season. Curious how many of you follow this, as it got me thinking I may have been inflicting some damage on the engine. Cheers

        That always seemed silly to me. New oil will perhaps gain a tiny bit of water over the winter from condensation if it's in a humid climate with large daily temperature changes, but that water will just boil off the first time the engine gets hot anyway. I think they are just trying to sell more oil.
        http://img.photobucket.com/albums/v5...tatesMap-1.jpg

        Life is too short to ride an L.

        Comment


          #5
          makes no sense to me,
          if you are going to change it in the spring again, just drain it in the fall and don't ad the new stuff until spring.
          I don't change oil til I have time, halfway through winter.
          GSX1300R NT650 XV535

          Comment


            #6
            Change the oil in the spring. Putting Stabil in the tank WILL keep the fuel in the tank good but in reality doesnt do much for the carbs. Get a cat food can or tuna can and open the drains to drain all the bowls. let them rip till they stop and use a towel held against the drain screws to wick a little more out...wont be much but it will get a few drops more out of the bowls. Close the drains and in the spring it will start and drive like the day it was out away.

            I have read far TOO TOO many threads saying I put gas stabilizer "X" or "X" in and still my carbs are gumped up...what gives!! Well, what gives is the bike wasnt put away properly. I took my Cooley out of storage after 15 1/2 months, put gas in and primed the carbs. Rode away with not so much as a pause in performance.
            MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
            1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

            NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


            I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

            Comment


              #7
              It did seem a bit excessive to me as well, thanks for chiming in guys.
              1980 GS1100E

              Comment


                #8
                Originally posted by chuck hahn View Post
                Change the oil in the spring. Putting Stabil in the tank WILL keep the fuel in the tank good but in reality doesnt do much for the carbs. Get a cat food can or tuna can and open the drains to drain all the bowls. let them rip till they stop and use a towel held against the drain screws to wick a little more out...wont be much but it will get a few drops more out of the bowls. Close the drains and in the spring it will start and drive like the day it was out away.

                I have read far TOO TOO many threads saying I put gas stabilizer "X" or "X" in and still my carbs are gumped up...what gives!! Well, what gives is the bike wasnt put away properly. I took my Cooley out of storage after 15 1/2 months, put gas in and primed the carbs. Rode away with not so much as a pause in performance.
                What Chuck said, Stabil or the like will keep fuel from going bad in the tank, but it won't prevent it evaporating from the carbs and leaving a residue behind. If you are not 100% certain your petcock leaks absolutely nothing disconnect the fuel line too. All the float bowl draining in the world won't help if a leaky petcock just fills it back up again as it slowly evaporates away.
                http://img.photobucket.com/albums/v5...tatesMap-1.jpg

                Life is too short to ride an L.

                Comment


                  #9
                  And what Tom said too.
                  MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
                  1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

                  NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


                  I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

                  Comment


                    #10
                    Last few years I've actually used Seafoam as a fuel stabilizer, and with very good results. Adding one whole bottle to the full tank of gas, running the engine a bit so it gets in to carbs. Fires right up in the spring time, and the carbs seem fine.
                    1980 GS1100E

                    Comment


                      #11
                      I always fill and stabil the tank and run the bike a bit to get it in the carbs. Sometimes I drain the carbs, sometimes I don't and never had a problem either way. As acids and other nasty crap can collect in the oil I change the oil in the fall but not again in the spring, don't see much sense in that. Batteries come into the house and go on a battery tender every once and awhile. I don't just leave them on the tender. Every few weeks I rotate the tender around the batteries, we're talking RV, lawn tractor, pickup truck and a couple of motorcycle batteries. The bikes, chain saws, lawnmower and other vehicles always start right up in the spring. Procedure for a bike is usually turn to prime and fill the carbs while installing the battery and start. If a bike didn't get ridden or summerized I'll drain the old gas into my work van and rewinterize as above. Been doing it for years and never had storage issues. Oh yeah, also make sure the bike is as clean as possible as dirt hiding out of site can attract moisture.
                      '84 GS750EF (Oct 2015 BOM) '79 GS1000N (June 2007 BOM) My Flickr site http://www.flickr.com/photos/soates50/
                      https://farm5.staticflickr.com/4306/35860327946_08fdd555ac_z.jpg

                      Comment


                        #12
                        Like I said, if your petcock is perfect that works fine. If it leaks even a little bit I hope you enjoy the time spent cleaning carburetors.
                        http://img.photobucket.com/albums/v5...tatesMap-1.jpg

                        Life is too short to ride an L.

                        Comment


                          #13
                          Originally posted by tkent02 View Post
                          Like I said, if your petcock is perfect that works fine. If it leaks even a little bit I hope you enjoy the time spent cleaning carburetors.
                          True enough and something to consider. Never had a problem yet with carbs stored dry or wet. Guess if the petcock was bad it could flood your crankcases too. Been doing it this way for 50 years, lucky I guess.
                          '84 GS750EF (Oct 2015 BOM) '79 GS1000N (June 2007 BOM) My Flickr site http://www.flickr.com/photos/soates50/
                          https://farm5.staticflickr.com/4306/35860327946_08fdd555ac_z.jpg

                          Comment


                            #14
                            Cheers, thanks for suggestions!
                            1980 GS1100E

                            Comment


                              #15
                              Must be lucky, or maybe you actually maintain the bike once in a while. I've bought dozens of used GSes which were dead from being stored wrong, with carburetors clogged to the point of not running at all being by far the most common problem.
                              http://img.photobucket.com/albums/v5...tatesMap-1.jpg

                              Life is too short to ride an L.

                              Comment

                              Working...
                              X