wheel bearing inspection question

[Guest]

80 GS850G (13K miles) with unknown maintenance:
I have pulled the front wheel to clean it up, inspect it, etc. Both bearings turned smoothly with no sticky points or crunchiness. They feel damped but smooth. Is that all I am looking for? Should I replace them anyway or is this enough to know that they are okay?
Thanks for any help.
Peter

Also, I am sure that this has been answered before but when I search, I come up with nothing. Is there some trick to searching these forums?

[Nessism]

I'd leave them alone. Those OEM bearings were high quality pieces. The only thing that causes them to fail (other than high mileage) is water entry. It sounds like you don't have either of these issues though.

[bwringer]

I'd leave them alone. Those OEM bearings were high quality pieces. The only thing that causes them to fail (other than high mileage) is water entry. It sounds like you don't have either of these issues though.

Agreed. If they feel reasonably smooth they're fine.

[storm 64]

I'd leave them alone. Those OEM bearings were high quality pieces. The only thing that causes them to fail (other than high mileage) is water entry. It sounds like you don't have either of these issues though.

Another nemesis to wheel bearings is SAND! My 1000e lived most of it's life in Florida, that sand gets everywhere. My front wheel bearings felt a little crunchy so I decided to replace all my wheel bearings. A cheap piece of mind.

[steve murdoch]

Peter, have a look at the top of this page for some search info.

http://www.thegsresources.com/_forum/faq.php?faq=vb3_board_usage#faq_vb3_search

When i am searching for something i get better results when in "advanced search" if i am using "Search single content type"

[Peter Buehner]

Thanks for the replies. I am leaving them be. On to the shocks next!
Steve, thanks for that link to the search info.

Peter