Announcement

**SqDancerLynn1** · 03-13-2005, 04:35 AM

With the stator wires disconnected if you are only getting 20 VAC the stator is bad --- Make sure you are checking for AC voltage from one wire to one of the other two & so on.

**earlfor** · 03-13-2005, 11:19 AM

Re: Stator 750L

Are you checking AC voltage between pairs of stator output leads at that rpm with the stator disconnected?

If so, then the stator is faulty.

Earl

Originally posted by Wingnut

Not charging.
Has anyone had this scenario? I am only getting 20 VAC out of the stator @ 4500 RPM's. However, all of the leads measured between 1 and 2 ohms and all were above ground. I ordered a new one anyway, (can't get Elextrex they are way on back order, got one from DK, Rick's) but now I am second guessing myself. I think, maybe I'm not, but I could be.

**Wingnut** · 03-13-2005, 08:12 PM

Re: Stator 750L

[quote="earlfor"]Are you checking AC voltage between pairs of stator output leads at that rpm with the stator disconnected?

If so, then the stator is faulty.

Earl

Yes. I only got 20VAC between the three wires disconnected. Has anyone used a "Rick's" stator? Are they any good? I ordered one form Dennis Kirk because Electex was on a two month backorder. Hoping it works OK.

bob

**alan** · 03-23-2005, 10:58 PM

So, I checked on my Electrex stator order today and they said it will be a minimum of 1 month before I can get mine. I'm thinking that Rick's is looking pretty good. My learner's permit is only good for 90 days.

**Wingnut** · 03-24-2005, 10:10 PM

Originally posted by alan

So, I checked on my Electrex stator order today and they said it will be a minimum of 1 month before I can get mine. I'm thinking that Rick's is looking pretty good. My learner's permit is only good for 90 days.

I put the Rick's in and it is working good right now. Hope it lasts. $20 cheaper than Elextrec.

Announcement

Stator 750L

Stator 750L

Comment

Comment

Comment

Comment

Comment