Announcement

Collapse
No announcement yet.

Carb I.D.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Carb I.D.

    How do you I.D. jwhat type of Carb you have. I know they are minuki carbs but not sure what part number. They are on a 81 gs1100. I am tring to figure out what vent/fuel line goes where. there are two large diameter vents I believe are for the bowls. Three smaller ones that I have no idea. I looked at the carb clean up link on this page but my particular set up is way different. Any help would be appreciated. thanks Gary

    #2
    Need4Speed 81gs1100 Carb I. D

    go to www.dansmc.com this my .

    Comment


      #3
      Carbs I.D

      You can also try www.mikuni.com Hope this helps

      Comment


        #4
        Thanks Dan I will check it out. But, I finally got a hold of the Dealer/shop owner and he is going to look at my scoot since I did give him $419.68 to clean, syn, and tune the bike the first time around. I just hope it gets done right this time.

        Comment


          #5
          If he didn't get it right the first time, what are the chances he will succeed the second time. I'm in Lincoln and could give you a hand.

          Comment


            #6
            You are most likley right arveejay They most likley won't get it right but, I will give them a second chane to redeem themselves.And from what I gathered the tech that did the work is no longer employed there. I guess they figured out the guy was a moron. When I told the shop about the problems I was having (e.x. the #2 plug wire on the #1 plug and vise versa and the vent/fuel lines were on excactly the way it brought in which I told them was wrong to begin with.) they asked me what tech number was on my work order and before I could finish they said he is gone. If it is not right I will defintley look you up for some help. Thanks gary

            Comment


              #7
              Good luck, hopefully they'll do better.

              Comment

              Working...
              X