part # carb to airbox boots GS1000 78/79???

[robinjo]

part # carb to airbox boots GS1000 78/79???

Can't find the number listed. :?
They are sold seperately aren't they?

Thanks in advance for your help!

[robinjo]

If some one has the answer for me in the next 37 minutes (bcause I can still order them before the shop closes for the weekend) I will send them a packet of stroopwafels! I mean it!

[wrench]

I found this number Robin 13110-49000

[robinjo]

I found this number Robin 13110-49000

Packet of stroopwafels coming your way John, mail me your adress!

[wrench]

I found this number Robin 13110-49000

Packet of stroopwafels coming your way John, mail me your adress!

Just check with the dealer that it is the right #

[robinjo]

I found this number Robin 13110-49000

Packet of stroopwafels coming your way John, mail me your adress!

Just check with the dealer that it is the right #

The thing is the dealer couldn't find a seperate part number for them either, they called me back asking if I'm sure they are seperate part and not one with the plenum chamber. I put the number in Google and got a reference on a few parts sites: http://www.google.nl/search?hl=nl&q=13110-49000&meta=

And if they are the wrong ones I will send you the bill WOEHAHAHAHA :twisted:

*Goes off to buy a packet of stroopwafels for Wrench

[wrench]

Just check Alphasports under aircleaner, thats what i did

[wrench]

I think that # is for the manifold intakes

[robinjo]

I think that # is for the manifold intakes

Crap, you're right. It is the updated part number.

[robinjo]

Well the verdict is in
They are not sold seperately from the airbox, I am out of luck.
Anybody have any other otions? :?
Or four fitting K&N filters they wanna sell?

[earlfor]

I just checked and it appears for the 1000, you have to buy the airbox to get the tube outlets. I recently bought new airbox to carb tubes/rubber boots for my 83 1100. They are part number 13881-49021 (replaces 13881-49020) and they cost $5.86 each (USD) I think the end that goes into the airbox will be the same for my 1100 and your 1000. I just went into the shop and measured the inside diameter of one of those boots. It fits a 55mm carb flange. You may be able to use them if you put a wrap of rubber insulating tape around your carb flange.

Earl

Well the verdict is in
They are not sold seperately from the airbox, I am out of luck.
Anybody have any other otions? :?
Or four fitting K&N filters they wanna sell?

[saaz]

Except the 78/79 GS has slide carbs, not CVs, so the diameter is different. I used to have the original airbox somewhere, with a K&N filter in it. Seems to be lost ..hmm...

[earlfor]

I know. :-) I was thinking it may be feasible to adapt them if that is all that is available.

Earl

Except the 78/79 GS has slide carbs, not CVs, so the diameter is different. I used to have the original airbox somewhere, with a K&N filter in it. Seems to be lost ..hmm...