Any trouble shooting ideas would be much appreciated.
Announcement
Collapse
No announcement yet.
1980 GS1000E stalling when coming to a stop
Collapse
X
-
Anonymous
1980 GS1000E stalling when coming to a stop
I've recently got some work done on my 1980 GS1000E. They cleaned the carbs, replaced air filter, new plugs, etc. It's been running great, however, I've recently had this problem when coming to a stop, the bike stalls. It starts up no problem and when riding it's smooth but when I shift down it will stall right before I stop. When I start it back up, it will idle fine and not stall, it's just when I come to a stop.
Any trouble shooting ideas would be much appreciated.Tags: None
-
bjrehill
It almsot sounds like you have an air leak. Maybe the intake boots have a crack. Try spraying wd40 on the boots to see if the RPMs change. If they do you have a leak.
-
Anonymous
Comment
-
LW_Icarus
intake boots are between the carbs and the cylinder head. usually a two piece affair with rubber bonded to aluminum.
also worthwhile to see if the carbs need resynched, and make sure idle is in the 1100 rpm + range.
Comment
-
i had a similar problem with my bike, check you float hieghts and and if they are good then try lean the bike out just t tiny little bit by droping the needle a half step see if that helps.
-ryan78 GS1000 Yosh replica racer project
82 Kat 1000 Project
05 CRF450x
10 990 ADV-R The big dirt bike
P.S I don't check PM to often, email me if you need me.
Comment
Comment