Announcement

Collapse
No announcement yet.

gas tank rust - get the flakes out?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    gas tank rust - get the flakes out?

    I bought a length of chain, removed the fuel gauge and petcock. Now that the tank is dry and scraped out by the chain, how do I get all those little pieces of rust etc. out?

    I have shaken it all around and it still sounds like a child?s rattle. Any tricks?

    I have some magnetic tape I was thinking about stringing down in there but other than that am at a loss.

    Thanks

    #2
    Go down to your local car wash, with a small hose, duct tape and a few quarters. That should do it.
    1166cc 1/8 ET 6.09@111.88
    1166cc on NOS, 1/8 ET 5.70@122.85
    1395cc 1/8 ET 6.0051@114.39
    1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
    01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82

    Comment


      #3
      Compressed air will do it, just wear glasses.

      Drop a small speaker magnet tied to a string, Shake it until the noise stops and then pull the magnet out.

      Hire a midget to climb in the tank and pocket the rust. Pay him 10 cents a piece and 25 cents for the really big ones. :P
      1981 GS650G , all the bike you need
      1980 GS1000G Power corrupts, and absolute power corrupts absolutely

      Comment


        #4
        I removed the sender, the stopcock and the cap. I put a shop vac hose in the hole for the sender and shook it. Seemed to work good.

        Comment


          #5
          Rinse, drain, repeat! It may take a while, but it will eventually get it all out.

          Brad tt

          Comment

          Working...
          X