2-Ton Floor Jack

**moto_dan** · 10-31-2002, 12:53 PM

Re: 2-Ton Floor Jack

Originally posted by Sebby

Have you ever used a floor jack to raise your bike ?
I removed a center stand during a pipe conversion job.
I miss the convenience of having the bike perched on the center stand while I perform some routine (or not so routine) fixes. :roll:

:roll: Anyway... could I use a regular floor jack if I had too ??

Any special concerns or precautions ??

Thanks folks

I've used one on many occassions. Use a block of wood between the saddle and engine, if you're jacking on the oil pan.

**Anonymous** · 10-31-2002, 04:09 PM

Thanks Dan. Is there anyother jacking point?
Or is the oil pan pretty much it.
Is there a spot on the frame, infront of the rear tire, a good jacking point ?

Thanks for the block suggestion

**argonsagas** · 10-31-2002, 07:50 PM

There is no other legitimate lifting point. You cannot balance the bike anywhere else, so anywhere else is asking for trouble. Definitely works...it's all I have ever used.

VERY important that you use a wood cushion to avoid damaging the aluminum parts, and to spread the load, or get yourself a hydraulic bike lift/stand. I have never used one of those, but many people think they are so good they should be considered essential.

**Anonymous** · 11-01-2002, 03:34 AM

I just use a standard car jack, for lifting the front I put the jack underneath the motor and it leans the bike onto its sidestand and rear wheel. For lifting the rear I put the jack under the swingarm and it leans the bike on to the sidestand and front wheel. Never had any problems, I even did it on a slope once and it was still as solid as a rock.

**Anonymous** · 11-01-2002, 11:29 AM

Thanks for the tips.

I still miss my center stand...wish I could've worked around the pipe mod.

But atleast I have a good "solid" alternative.

2-Ton Floor Jack

2-Ton Floor Jack

Comment

Comment

Comment

Comment

Comment