Announcement

Collapse
No announcement yet.

Leaking banjos, what to do?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Leaking banjos, what to do?

    Aaaarh, starting the '79 1000 up, after only a few seconds fuel started pouring out of the carbs. After shutting off and tracing i found out that the banjos connecting the carbs are leaking.

    I think/fear the rubber has deteriorated due to age and is now not flexible or thick enough to create a tight seal. So, tore the carbs apart and have sought all over for new ones...



    Can anyone help me on what to do ?
    Replace with new, but where do i get them?
    grind the old rubber edges off and replace them with O-rings?
    Coat them with liquid sealant and shove 'em back in?
    Buy new flatslides, a big bore kit and overhaul the engine? \\/

    Thanx !

    #2
    Yikes, listed as discontinued!

    If it were me, I would probably find a newer set of carbs that have more parts available, but in the meantime I'd probably use some sealant.
    Currently bikeless
    '81 GS 1100EX - "Peace, by superior fire power."
    '06 FZ1000 - "What we are dealing with here, is a COMPLETE lack of respect for the law."

    I ride, therefore I am.... constantly buying new tires.

    "Tell me what kind of an accident you are going to have, and I will tell you which helmet to wear." - Harry Hurt

    Comment


      #3
      Use a small O ring on the fitting When it is squished together on assembly it will seal them. If you are really stuck you can get a replacement from www.motorcyclecarbs.com $$$$$

      Comment


        #4
        Thanx for the replies.

        Think i'll go with the O-ring, ans throw in some sealant in the carb housing for good measure... oh yeah, and save up for ne carbs :-)

        Comment


          #5
          Half a dozen wraps with teflon tape may also allow the ends to seal.
          Earl
          Komorebi-The light filtering through the trees.

          I would rather sit on a pumpkin and have it all to myself than be crowded on a velvet cushion. H.D.T.

          Comment


            #6
            What kind of sealand would be trustworthy around gasoline?? It seems to eat through just about anything you can throw at it.

            Comment


              #7
              I wouldn't use sealant. Too easy for it to end up in the carbs and clog passages. O-rings are your best bet.

              Comment

              Working...
              X