please advise on grips

[Mike_H]

Not Hokey at all...Unless I'm hokey too :mrgreen: I did the electrical tape thing for my left hand grip too.

I found out when putting on my new grips they were very very tight on the throttle side and a bit loose on the clutch side. I had to use a rubber mallet and a little water to put the throttle side on. I domed the edge of the throttle as well as the grip with a small file which makes instalation a little bit easier and does not affect the fitment. If you have a loose grip you can use super glue or some silacone. I have had great luck with electrical tape on the bar to make the grip fit tighter. It can make the grip hard to get off come replacement time though!! Some of you may read this and find these ways a bit hoaky. But they are cheap fixes for the poor man. also on rubber grips put them in hot water first or set them out in the sun. This will help alot

Pan