Bench Syncing Carbs

[Guest]

I'm looking for a good desription on how to bench sync my carbs. I upgraded to 36mm mikunis from a 95 RF900. Cleaned and installed larger mains. These are on my 83 GS1100E. I set the mixture screws at 1 1/2 out to start. THis rack has 3 idle screws, 1 each for the outer carbs and 1 for the inner pair.

Thanks,
Stiksave

[stiksave]

Never mind. I did a search and found what I needed. I did the bench sync and it fired right up. The info was perfect, gotta love this place.

Stiksave

[smithbm]

Could you do me a favor and post the thread that helped you out? It would sure save me some search time when it's my turn to do the deed.

[stiksave]

This actually from another site. It's dead on though.

http://www.xs11.com/forum/showthread.php?threadid=88

Thanks,
stik

[smithbm]

Thanks for the link.