I took it home in a truck and fired it up. She ran, but had little power when I took her around the block. Then she died. I then let her cool down and she ran fine, but died again. So, I took the carbs off and found that one had a clogged jet and the other was similar but not as bad and passed some fuel. I cleaned them both with carb cleaner, reassembled and put them right back on. I turned her over and she fired right up again. This time she was running smoother, though idleing a little high so I adjusted that (continues to be erratic -suspect vacume issue). I took her around the block again and WHOA!!! She gets up and gets!!! Plenty of power; there was not a problem with the clutch, just a dirty carb!
Now, for the problem... When she gets up to normal operating temp, the motor runs real 'slow' and eventually dies. This occures a little after 10mins of running. Will not start up again until she cools down.
I let it cool down and road it around the block again. It ran fine then I let it sit until normal operating temp. Like clock work the engine got weak and eventually died (even if I twisted the throttle). Right when it died I took the plugs out and did a compression check, no problem there. The spark plugs are black, but do not have oil. The plugs are new.
Something is telling me,... timing. Is it pretty tough to set timeing on these type of bike? I notice that it does not have points, but some type of electronic ignition.
Comment