.png "Powered by vBulletin")
My turn signals don't work. I have tried a new relay and it doesn't make any difference. It is a 3 prong plug and only to posts on the relay. The power wire going into the relay does't line up with either of the 2 posts. This is the Suzuki factory relay. When I run the power to one of the posts with a jumper the signals will come on with the switch but won't flash. Please help I'm not very good with wiring.
-
-
First, try to find a 3-prong relay. It really does make a difference.
If you can't find one, toss an e-mail my way, I have one sitting in the drawer.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.) -
Did someone replace the bulbs? They need to be 1073 bulbs. Others look the same but are rated at other voltages.Comment
-
My '83 GS750ES also had a three prong plug with a two prong relay in it. When it went bad I got a three prong electronic relay and it didn't work. I got a two prong electronic relay and haven't had a problem with it since. Been in there 5+ years. The electronic ones are not as sensitive to voltage and resistance levels and I highly recommend them.Comment
-
Check that the signals are grounding well. That is often a problem with the rubberstalk signals.Comment
-
does the loom have a signal control unit if so disconect it and try the indicators,with this out it will not effect anything else on the electrics
shepComment
Comment