.png "Powered by vBulletin")
push button start and a toggle (2prong)
ive put a 78 gs 750 motor on the back of a small dune rail and cant figure the wiring out for the starter.im a little slow so bear with me....
4 starters,i run a dyna s and aftermarket coils with a ford starter silonoid.the hot from the battery runs to one side of the silonoid.from the same spot on the silonoid,i have a wire running to one prong on a push button starter for a hot.the second prong of the push button has a wire hooked to it running to the s on the starter silonoid.and now the other side of the starter silonoid has the starter wire hooked to it.this way i push the button and around she goes.now running with the dyna requires a switched 12v to operate.i ran from the hot on the push button to a toggle prong and hooked the dyna wire + to the opposite toggle prong.switch forward is on and backward is off.turn the toggle on and push the button gives the gs life..........until i let the push button go,shell die.if i hold the button(fried 1 starter)of course she stays running but so does the starter.can anyone tell me the proper way to bypass original key and just run a toggle set up like i have?im so close,its gotta be a simple fix but im stuck.details would be greatly appreciated...thanks for your time,mike..........
4 starters,i run a dyna s and aftermarket coils with a ford starter silonoid.the hot from the battery runs to one side of the silonoid.from the same spot on the silonoid,i have a wire running to one prong on a push button starter for a hot.the second prong of the push button has a wire hooked to it running to the s on the starter silonoid.and now the other side of the starter silonoid has the starter wire hooked to it.this way i push the button and around she goes.now running with the dyna requires a switched 12v to operate.i ran from the hot on the push button to a toggle prong and hooked the dyna wire + to the opposite toggle prong.switch forward is on and backward is off.turn the toggle on and push the button gives the gs life..........until i let the push button go,shell die.if i hold the button(fried 1 starter)of course she stays running but so does the starter.can anyone tell me the proper way to bypass original key and just run a toggle set up like i have?im so close,its gotta be a simple fix but im stuck.details would be greatly appreciated...thanks for your time,mike..........
Comment