Announcement

Collapse
No announcement yet.

QUESTION - Pinks bike --- 82 GS1100 ------QUESTION

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    QUESTION - Pinks bike --- 82 GS1100 ------QUESTION

    Sorry if you have seen this as a double post.

    BUT -- Thought might get more for it here.


    OK - I have told you before about riding my bike to work and a co-worker saying he inherited his brothers RAGGED OUT 82 GS 1100.

    This co-worker has been fiddling with this bike for a while and has it running.

    I saw it and man it was thrashed................................

    Anyhow he had a question and I could not answer.

    HELP if you can.


    - Siting on bike cylenders from left to right - 1,2,3,4
    When the bike is cranked over and is warming up-

    # 2, 3, cylanders warm up and pipes by head get hot quickly.
    # 4 warms up (but a little slower) and gets warm then hot
    #1 this cylender seems to take a considerable longer time to warm up.
    enough to where after the bike has been running a couple minutes you can tap the pipe and it not be near as hot as the others (cool in comparison) yet not cool , you know.

    Anyhow - his bike seems to run well.
    No spit or sputter.
    Sounds good - but

    Just the pipe heat difference - any answers ?


    -

    #2
    Is the cold pipe syndrome only while it's on choke? Have the carbs been cleaned recently? If it runs good, it may just be the choke circuit. Valves adjusted? I would do some chop tests on it to see if it really is running the way it should.
    85 GS1150E May '06 BOM
    79 GS1000S Wes Cooley Beast





    Comment


      #3
      Originally posted by getsum View Post
      Sorry if you have seen this as a double post.

      BUT -- Thought might get more for it here.


      OK - I have told you before about riding my bike to work and a co-worker saying he inherited his brothers RAGGED OUT 82 GS 1100.

      This co-worker has been fiddling with this bike for a while and has it running.

      I saw it and man it was thrashed................................

      Anyhow he had a question and I could not answer.

      HELP if you can.


      - Siting on bike cylenders from left to right - 1,2,3,4
      When the bike is cranked over and is warming up-

      # 2, 3, cylanders warm up and pipes by head get hot quickly.
      # 4 warms up (but a little slower) and gets warm then hot
      #1 this cylender seems to take a considerable longer time to warm up.
      enough to where after the bike has been running a couple minutes you can tap the pipe and it not be near as hot as the others (cool in comparison) yet not cool , you know.

      Anyhow - his bike seems to run well.
      No spit or sputter.
      Sounds good - but

      Just the pipe heat difference - any answers ?


      -
      Probably carb issues, as has been noted, but keep in mind the two problem pots share the same coil So check the coil as well, easiest way would be to simply swap the leads.

      Also...what the heck does 'pinks' have to do with this?

      Comment


        #4
        I was just giving reference that he has a bike that looks like the one that beat the V-rod HARLEY on PINKS.

        I will tell him to flush the carbs and check the compression.

        Thanks guys.

        BTW- I believe he said it was fine once it warmed up - so I am guessing it is like that while the CHOKE IS ON .. and it is warming up.

        -Why would that matter - I aminterested in knowing for myself.

        THANKS again.

        Comment


          #5
          The choke circuit is seperate from the rest of the system. It could be gunked up. Once the bike is warm the choke circuit is shut off and the bike runs off of different air and gas jets.
          85 GS1150E May '06 BOM
          79 GS1000S Wes Cooley Beast





          Comment


            #6
            Clean the carbs. Adjust the valves. Sync the carbs.
            1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
            1985 GS1150ES stock with 85 Red E bodywork.

            Comment


              #7
              :-D

              GOTCHA - THANKS FOR THE INFO.


              BEST PART IS -

              I will help him do his and see the inner workings of the carbs (without ripping mine apart)
              THUS- I can later do mine without flying blind.

              HE WILL BE THE TEST PIECE....

              Comment


                #8
                I had the same problem cold.It ended up,after trying everthing else,being the carbs out of sync.Even a very small adjustment will make or break it.

                Comment

                Working...
                X