1074 motor cylinder base Oring?

[Ed74mnd]

Guys,

I'm about to put my Wiseco kit in but was reading my CLymer manual first.

there appears to be an oring at the base of each cylinder?

Does anybody have the part number for this item?

Cheers

Ed

[feelergaugephil]

I might have one of those, is it oval looking ? (pear shaped)

[Ed74mnd]

Hey Phil,

I have no idea, was only reading the manual fist to ensure i have everything required for a smooth job.

haven't actually torn the motor down yet, here in Australia parts can sometimes be a wait.

Cheers

Ed

[Ed74mnd]

just found it using bikebandit.

472134-001 cylinder o-ring.

Cheers

Ed

[Dink]

Ed BTW you need four of them.

Dink

[Suzuki mad]

Check the bottom of the barrels that the 4 recess's do not have either old 'O' rings in or bits of rubber gasket. Then make sure that they are firmly pressed into place prior to installing the barrels.
These little s*d's do move at it is very easy to pinch one while installing the barrels. (I've done this job....)

Suzuki Mad
1981 GS1000ET
1983 GS(X)1100ESD
2002 GSF1200K1

[Ed74mnd]

thanks for the replies and advice guys,

will ring the local suzuki dealer for 4.

Cheers

Ed