Announcement

Collapse
No announcement yet.

Earthing points

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Earthing points

    I have run a new from Batt earth to my RR & cleaned up most of the connectors on my bike.

    I still get something that looks like a weak earth when using the indicators, the headlight will dim in time to the flash etc. Same when the brake light come on or I use the horn.

    Anyone else added an extra earth strap from the battery & if so where did you choose to put it?

    Anyone know which earth is for the indicators, that seems a likely first place to look..... \\/

    Cheers,

    Dan
    1980 GS1000G - Sold
    1978 GS1000E - Finished!
    1980 GS550E - Fixed & given to a friend
    1983 GS750ES Special - Sold
    2009 KLR 650 - Sold - gone to TX!
    1982 GS1100G - Rebuilt and finished. - Sold
    2009 TE610 - Dual Sporting around dreaming of Dakar..... - FOR SALE!

    www.parasiticsanalytics.com

    TWINPOT BRAKE UPGRADE LINKY: http://www.thegsresources.com/_forum...e-on-78-Skunk/

    #2
    Check & make sure you are not dropping voltage thru the ign switch

    Comment


      #3
      Can I just put a meter on each side of it & measure the voltage? I'll have to see if I can get behind there & have a clean up of the contacts etc.

      I'm still planning to run at least one more earth though....

      Dan
      1980 GS1000G - Sold
      1978 GS1000E - Finished!
      1980 GS550E - Fixed & given to a friend
      1983 GS750ES Special - Sold
      2009 KLR 650 - Sold - gone to TX!
      1982 GS1100G - Rebuilt and finished. - Sold
      2009 TE610 - Dual Sporting around dreaming of Dakar..... - FOR SALE!

      www.parasiticsanalytics.com

      TWINPOT BRAKE UPGRADE LINKY: http://www.thegsresources.com/_forum...e-on-78-Skunk/

      Comment


        #4
        Compare the readings from the battery to the Orange wires on the fuse block reading should be the same

        Comment


          #5
          The headlight dimming a bit in time with the blinkers is not necessarily indication of a problem. The two blinker bulbs draw about the same current as another headlight bulb, :shock: and the charging system just can't handle it all. Some bikes have one tail/brake bulb, others have two. If yours is one of the models with two, the same thing is happening. The two brake filaments draw the same current as a headlight bulb.

          Put a voltmeter across the battery terminals, start the bike. At idle, measure the voltage, then turn on the signals and measure again. My guess is that you will see the voltage fluctuating with the signals.

          How old is the battery? This might be one of the first indications that it is time to replace it.


          .
          sigpic
          mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
          hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
          #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
          #2 son: 1980 GS1000G
          Family Portrait
          Siblings and Spouses
          Mom's first ride
          Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
          (Click on my username in the upper-left corner for e-mail info.)

          Comment


            #6
            As for another ground, you can run one to any of the engine case bolts under the carbs. I picked one right in the middle which also held a strap for some of the wiring. I also used a spade connector instead of a ring so I only had to loosen the bolt slightly to hook up the ground.

            josh

            Comment


              #7
              Well I have the equipment & wire etc to add another ground so I might just do it for peace of mind. A couple of grounds go to a bolt on the battery box side plate so it's only getting earth through multiple bolts etc. Might run one there & a 2nd to the engine, can't hurt.

              Steve - I wondered the same, it only does it with indicators, horns, brake - all extra loads in fact. I have an aftermarket stator (all 3 wires are white) & when I was playing with the rectifier the charging voltage is not quite as high as some (13.6v from memory) but it was very consistent at all RPM's.

              The battery was new just before I bought it so approaching 1 year, seems to be strong & it's always done this so probably not that; although 1 cell was a bit low on water when I checked it (but it hadn't been checked for at least 6 months probably longer).

              Thanks for the help as always!

              Dan
              1980 GS1000G - Sold
              1978 GS1000E - Finished!
              1980 GS550E - Fixed & given to a friend
              1983 GS750ES Special - Sold
              2009 KLR 650 - Sold - gone to TX!
              1982 GS1100G - Rebuilt and finished. - Sold
              2009 TE610 - Dual Sporting around dreaming of Dakar..... - FOR SALE!

              www.parasiticsanalytics.com

              TWINPOT BRAKE UPGRADE LINKY: http://www.thegsresources.com/_forum...e-on-78-Skunk/

              Comment


                #8
                Get that bike in shape. I'm not riding the San Joaquin Valley by myself! Well, only if I have to.:?
                1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
                1985 GS1150ES stock with 85 Red E bodywork.

                Comment

                Working...
                X