.png "Powered by vBulletin")
that go on the valve cover/tray ends? Using a bit of teflon tape now, but want to replace them all eventually...
THanks!!
TCK
THanks!!
TCK
-
-
Look under cylinder head part #18 here1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
-
Good one that!! Thanks man!!Comment
-
1980 GS1000G - Sold
1978 GS1000E - Finished!
1980 GS550E - Fixed & given to a friend
1983 GS750ES Special - Sold
2009 KLR 650 - Sold - gone to TX!
1982 GS1100G - Rebuilt and finished. - Sold
2009 TE610 - Dual Sporting around dreaming of Dakar..... - FOR SALE!
www.parasiticsanalytics.com
TWINPOT BRAKE UPGRADE LINKY: http://www.thegsresources.com/_forum...e-on-78-Skunk/Comment
-
85 GS1150E May '06 BOM
79 GS1000S Wes Cooley Beast
Comment
-
I got a set of the aluminum ones... they have a lip on both sides, mine would not fit until I ground off the inside lip with a dremel. Then they fit perfectly. Unfortunately two are leaking (very slightly) but I think that's my fault. I used black RTV on them, I am thinking of replacing that with JB weld or something next time I do my valves.Comment
-
Well i had a decent leak in one after doing the valve adjustment, but i took steves advice and used some teflon tape on it, worked like a charm. And thanks to chef i found new ones..they'll be goin in this winter for sure..:-DComment
-
ULTRA BLUE also works a treat under the seals.Comment
Comment