Which Plug Wires for a GS1150 with Dyna Green Coils?

[Guyver]

I have some Dyna Greens that I bought and I need to throw some plug wires on them and get them on the bike. Any suggestions for the size and brand to go with that is pretty commonly available?

[Ghostgs1]

I used a set of dyna wires, I believe they are 7mm, non resister. Bought them from Z1 for around $17 I think. Seem to work well with the green coils and dyna ignition module. If you order them don't make the stupid mistake I did, I bought two sets thinking I needed 4 wires not realizing there are 2 wires in a set which you then cut to length near the center giving you 4 wires. Ray

[BlackStar]

Do yourself a favor. Get the proper crimp tool for the terminals. The plug end is allready attached, The coil end is not. If they are not crimped properly they will not go into the coils very easy, and will come off if you try to remove them later.

[psyguy]

http://www.z1enterprises.com/detail.aspx?ID=209

[bwringer]

I'm using a set of Accel wires from the local auto shoppe.

Since it's for a Chevy V8 or somesuch, I got two sets...

(In other words, just about any wires will work fine. There's nothing magical about motorcycle plug wires or Dyna coils.)