.png "Powered by vBulletin")
Any idea on where I can obtain the fuel line tee piece that goes between carb number 2 and 3 and the straight feed which goes between - 1 and 2 and 3 and 4 - to fit VM28SS carbs -
-
-
I have a set on ebay for a dollar the whole bank you can disassemble.SUZUKI , There is no substitute -
Get out your wallet and grease up your poor Visa card...
1983 GS850G, Cosmos Blue.
2005 KLR685, Aztec Pink - Turd II.3, the ReReReTurdening
2015 Yamaha FJ-09, Magma Red Power Corrupts...
Eat more venison.
Please provide details. The GSR Hive Mind is nearly omniscient, but not yet clairvoyant.
Celeriter equita, converteque saepe.
SUPPORT THIS SITE! DONATE TODAY!
Co-host of "The Riding Obsession" sport-touring motorcycling podcast at tro.bike!Comment
-
VM28SS carbs
Thanks for the feedback and quick responses - I have tried all over the UK to get these parts -Comment
-
psychic
sometimes this site is scary....i was about to ask the same question. the prices on that site are.....cough cough....enough that there must be another option?1983 GS 1100 ESD :DComment
-
If you know someone with a lathe it's a simple matter to machine a Tee from a chunk of brass. A buddy did one for me for my 550. Failing that, you might want to check around at a kawasaki store since they used VM carbs on several different models in the 1970's. Bit of a long shot but you never know (photo below shows a Tee from a Z1000 and my homemade Tee).
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
Comment