Announcement

Collapse
No announcement yet.

Lookout carbs, we're coming in!...(hoping for some help too!)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    Originally posted by Suzuki_Don View Post
    1) What do I use to measure the height and where do I get one? You can buy a float measuring gauge, but most of us use a vernier caliper. They can be picked up cheap from hardware stores. About $10.

    2) If I need to make an adjustment, what do I "bend" :shock: (for lack of a better term)? The metal tang that sits over the top of the float needle is the part that needs to be bent to adjust the float height. See Pic.



    3) What do the numbers below mean for mine regarding float height and what type of measurement is this? This means 22.4 mm, plus or minus 1mm as the float measurement with the carb upside down on the bench. The figures in brackets are in inches. Measure from top of float, not top of float hinge to recess where you took the float bowl gasket away from. If gasket is still in place subtract another mm from the measurement.

    Hope this helps and you can understand it OK.
    Thanks Don! :-D

    Comment


      #32
      Originally posted by bwringer View Post
      Can you tell I have a nifty new program for annotating images?

      Bwringer, thanks for pointing out the tab and the notes you made! I was kinda unsure what the "tang" was. By the way, cool program you have! :-D

      Comment

      Working...
      X