Announcement
Collapse
No announcement yet.
no start
Collapse
X
-
niko
no start
i have an 85 gs550L that i cant get started. i cleaned the carbs sealed intake, replaced plugs and checked spark, all seems ok but it will still just crank and crank without firing. i tried ether and got a couple of backfires into the intake but still no joy. any ideas?Tags: None
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35618
- Torrance, CA
Did you prime the carbs and get the petcock hooked up correctly?
Remove the floatbowl drain screw to see if there is gas inside. If not, you have a supply issue.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
-
Like Nessism said, check first you getting fuel through. If fuel is getting to the carbs you need to prime them. An old trick which I posted on here a while ago, is to blow into the carb breather tubes, just a couple of puffs is enough. Sounds odd, but it works. Alternatively, turn the petcock to prime and leave for a minute or so, then switch it back to the normal position."Betsy" 1978 CX500 ratbike
1978 GS750
1979 GS750 chop
1979 GS550
2003 GSF1200 K3 Bandit
2000 Enfield Bullet 500
1992 XV750 Virago
2016 Harley 883 Iron
Comment
-
niko
there is fuel in the bowls, i checked that, and i'm pretty sure the carbs and petcock are functioning correctly. i was wondering about a timing problem or something like that, i checked compression but i don't know how to check timing, or could i have spark on the plugs when i pull them out but not under compression?
Comment
-
niko
ive never seen this bike run, when i got it it didn't have spark, i got a used tci igniter from a junkyard and that brought spark back but it still won't fire.
Comment
Comment