1981 650G Carburetor Replacement Screws

[Briandrex]

I'm in the process of cleaning my carburetors and have found out that I'm missing some screws from the float bowls and the diaphragm. First thing I'm trying to find out is the right size and for each one. I plan to order them off of Z1 Enterprises but when I look up my parts I have to choose between M5 and M4. I'm pretty sure as far as the sizes I'm going to order 12 mm and 14mm as the one screw is somewhat longer because of a lock washer.

Once I have the correct sizes my other question would be, is it worth it to order stainless steel screws with hex heads? I've seen this discussed before and wondered about any advantages to doing this.

I'm following the carb rebuild series and Mr. Orr's O-Rings are fantastic. Also Z1 Enterprises has been reasonably priced and quick with shipping on all parts so far.

[Steve]

I'm following the carb rebuild series and Mr. Orr's O-Rings are fantastic.

I am presuming that you mean Mr. Barr, but if you already got o-rings from him, why did you not get the carb screws, too?
You can order them by looking at this link and scrolling all the way to the bottom. 8-[

.

[chef1366]

I've got some extra screws. How many of each do you need?

[Briandrex]

I need about four of each. Some were missing and some are just plain ugly. How much do you want for them?

[Briandrex]

Steve.

I ordered those screws from Mr. Barr, for the intake boot. I'm looking for the float bowl and diaphragm screws. Maybe they are the same as the ones for sale there. If so I didn't realize it.

[Steve]

I may have mis-read the description, but I though he had packages for the carbs, as well.

It would not be the first time I made a mistake, but it might be the first time I admitted it. 8-[

.