Relay mod help

[nisom512]

Ok so I am doing the relay mod and I have the walk threw and the diagram but i dont understand what the thing tells me
I have a 81 550

I dont get what 86 is? is it the two orange combined into one?
then what the crap do I run from 87 it says its the power to the coils.

this is what I am looking at.

http://www.wgcarbs.com/index.php?option=com_content&task=view&id=12&Itemid=26

mind you I have never dont something like this before.

[BassCliff]

Hi Mr. nisom512,

Basically you are cutting the wire that powers your coils. Connect the coil side of the wire to 87 and the other side to 86.


Thank you for your indulgence,

BassCliff

[nisom512]

yeah I had to use some of the little common sence I have at 1am but I just got that thank you again for all your help I hope this is the solution to bad cold starts.
Thank you again Basscliff

[BassCliff]

Hi,

I think I read somewhere around here that hard starting when cold is a symptom of valve clearances that are too tight. Have you checked yours lately?


Thank you for your indulgence,

BassCliff

[nisom512]

nah /i guess I will do that once I am done with this. the soldering is becoming quite the chalange.

I dont even know if I am doing it right I just hope that teh wire doesnt have to be directly touching the connector cause there is like a mm of solder in between.:-D