.png "Powered by vBulletin")
my rotor needs to be replaced and before i start ineed to know if the crankshaft bolt is left hand thread - thanks
-
-
nevermind..... -
Nope, it's a normal right-hand thread. It is held in with thread locker, so it will take quite a lot of torque to crack loose.
Even when you figure something out or you think you might have posted a dumb question (and this was definitely NOT a dumb question), it's best to post the answer or solution here because it will very likely help someone else.1983 GS850G, Cosmos Blue.
2005 KLR685, Aztec Pink - Turd II.3, the ReReReTurdening
2015 Yamaha FJ-09, Magma Red Power Corrupts...
Eat more venison.
Please provide details. The GSR Hive Mind is nearly omniscient, but not yet clairvoyant.
Celeriter equita, converteque saepe.
SUPPORT THIS SITE! DONATE TODAY!
Co-host of "The Riding Obsession" sport-touring motorcycling podcast at tro.bike!Comment
-
was a good question really as a lot of people get it wrong.as bwringer says its a normal r/h thread but its a fine thread and should be fitted with threadlock so can make it a bitch to undo. an air gun makes easy work if you have access to one, but torque it up properly when refitting.1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!Comment
Comment