Announcement

Collapse
No announcement yet.

Carbureator problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Carbureator problem

    Anyone have any ideas for this. The new to me 1979 GS1000S has apparently been fiddled with. Someone has installed at some point the pilot needle screw into the idle adjusting mixture needle screw. Not surprisingly the hole in the idle adjusting needle location is far too large to allow the idle needle screw to work any longer. Any ideas to restore the lost diameter
    or do I need new carb bodies? AAAAARRRRGGGGHHHH. Thanks, Ray
    "Nobody goes there anymore, it's too crowded" -Yogi Berra
    GS Valve Shim Club http://www.thegsresources.com/_forum...d.php?t=122394
    1978 GS1000EC Back home with DJ
    1979 GS1000SN The new hope
    1986 VFR700F2 Recycled

    #2
    I don't know but fixing them but I have four Mikuni VM26 Carb Bodies with your name on it if you need em.
    Steve

    1979 GS1000E (45 Yrs), 1981 GPz550 (11 Yrs)

    Comment


      #3
      Ok, What do you need for them? Ray
      "Nobody goes there anymore, it's too crowded" -Yogi Berra
      GS Valve Shim Club http://www.thegsresources.com/_forum...d.php?t=122394
      1978 GS1000EC Back home with DJ
      1979 GS1000SN The new hope
      1986 VFR700F2 Recycled

      Comment


        #4
        Cannot let a GS1000S be sidelined; the Price is Right . . . just pick them up.

        Steve
        10071 Eaton Street
        Westminster
        Steve

        1979 GS1000E (45 Yrs), 1981 GPz550 (11 Yrs)

        Comment

        Working...
        X