Installing new fork seals and PS springs

[Bert Patterson]

I'm a little slow on this, but I just wanted to say thanks Billy, Simon, Pete, etc......

Got it all back together and everything worked fine, except it was a bitch to get the nuts off the top of the forks. Both bushings in either fork looked good, so I lucked out there. I'm keeping a rag in my tankbag to keep the bugs, etc., off the tubes.

I don't notice as much of a difference with the PS springs as I thought I would, but it wasn't bad to begin with. Maybe once I put the PS shocks on the rear I'll see more of a change.

Thanks again, folks.