Announcement

Collapse
No announcement yet.

Any coil recomendations?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Any coil recomendations?

    I intend on buying a new set of coils. Mine work ok, but they look mismatched. One of them doesn't even bolt onto both studs. I don't want to buy any used coils. I have a stock 82 GS 850L with the stock electronic ignition system. I was thinking of ordering a DYNA set out of Den Kirk. I Just need to know what specs I should stick to. I don't think I need to spend a lot of money on high performance ones. Thanks Chris.

    #2
    I just won an auction for a set off of a newer Katana 600. Look to be the same as stock GS items. I should have them next week and will measure resistance and let everyone know if they are adaptable. Could be a low cost way to replace your coils.

    Comment


      #3
      i just bought some accel coils from MAW and i am happy with them, they are cheaper then dyna coils and come with a mouting kit and wires, all for 124.00 for a 3 ohm system.

      ryan
      78 GS1000 Yosh replica racer project
      82 Kat 1000 Project
      05 CRF450x
      10 990 ADV-R The big dirt bike

      P.S I don't check PM to often, email me if you need me.

      Comment


        #4
        I don't want used.

        Are 3 Ohm concidered high performance. I would like them to be close to stock. I don't want any used coils. even off a newer bike they could have been abused. I know the ones on my bike have been. I used to ride at red line just about the whole way to work. I was 18 then with no kids.

        Comment


          #5
          3 ohm is what is needed with electronic ignitions. The stock coils are 3 ohm and aftermarket coils are various ratings depending on ignition type. There is nothing wrong with a good used coil. I am still using my 18 year old stock coils and I have ridden my bike very hard in all types of conditions. It is not something that is subject to abuse. They are either good or bad, and either have a strong or weak output. I had a set of Dyna coils that one went bad after only a couple of years. If I could figure out how to use the individual coils they run on the new Gixxers where the coil is built into the plug cap I would be using a used set of those.

          Comment


            #6
            Oh. Now I see the light.

            A little light just went on in my head. I need 12v 3ohm coils. the CDI .7 ohm coils wont work. Thanks.

            Comment


              #7
              I have accel ....paid 130 for the kit incl coils wires mounts and NGK plugs...Believe they throw a nice spark

              Comment


                #8
                some of us have found Dyna coils not an exact match for the stock mounting.

                Comment


                  #9
                  Thanks.

                  I think I'll lean toward the accel set. I would like them to bolt up the right way. Thanks again. Chris.

                  Comment


                    #10
                    my accel coils werent exactly an exact bolt up but fairly easy to deal with

                    Comment

                    Working...
                    X