Announcement
Collapse
No announcement yet.
Headlight
Collapse
X
-
Wilee7
Headlight
I have an 82 GS550L my low beam headlight won't work high beam is fine. i wsa looking online for a new headlight and i found one(see attachment) but its 2 seperate pieces does anyone know where i can buy a solid headlight or the lens so i can buy the bulb?Tags: None
-
Have you tried spraying an electrical contact cleaner (or WD-40) into the switch assy to clean dirty contacts?? Don't take it apart, LOTS of little bits & springs & things that go BOING in the night...
Make sure all the electrical contacts in the headlight bucket are clean - may just be something is dirty and/or corroded. Check the grounds too...
Good Luck,
Mike'85 GS550L - SOLD
'85 GS550E - SOLD
'82 GS650GL - SOLD
'81 GS750L - SOLD
'82 GS850GL - trusty steed
'80 GS1100L - son's project bike
'82 GS1100G - SOLD
'81 GS1100E - Big Red (daily rider)
-
A 1982 550 should already have a seperate bulb type headlamp assembly. Pull out the headlamp and have a look. Bulbs are available for cheap at any auto parts store.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
glenlloyd
The lamp is a separate unit from the bulb and you can replace the bulb with either a H4 or 9003 bulb available, as someone else mentioned, from most any autoparts store.
steve a
Comment
-
Wilee7
My bulb is a solid unit the number on the front of the bulb is M71 001 1014 the numbers ib the back are faded and hard to read
Comment
-
Check ebay for a replacment headlamp that takes an H4 bulb. Sounds like someone replaced yours for some reason. Measure the diameter of the lamp to make sure you get the proper size.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
Forum SageCharter Member
Past Site Supporter- May 2002
- 3869
- The Gulf Coast of south Florida in the winter and northern Nevada in the summer
Bulb?
Originally posted by Wilee7 View PostMy bulb is a solid unit the number on the front of the bulb is M71 001 1014 the numbers ib the back are faded and hard to read
The OEM lens was discontinued about 6 years ago and cost about $90 when they were available. I was lucky and found a brand new one, in the box, on Ebay for about $20 (as I remember).
As I'm sure you can see by looking at yours, you've got to get the right one or else do some major modifications or it won't fit (because of the built-on frame).Last edited by chuckycheese; 09-06-2008, 03:25 PM.1980 GS1100E....Number 15!
Comment
-
Eric73
If you have a Halogen light, that gold/brass ring on the back twists off and you can replace the bulb alone. Mine was and the guy at NAPA AUTO cross referenced a replacement 55/60 watt that works fine. If it is a sealed beam 7" round they carry those as well.
Comment
-
Wilee7
it is a sealed beam i'll try ebay for the lens and if i can't find it i go to napa I found a place that selld the halogen bulb but not the lens thanks for all of the help
Comment
-
Tarbash 27
Comment